RCF Structural Epoxy Injection Resin
01: PRODUCT & COMPANY IDENTIFICATION
RHINO PRODUCTS USA, INC.
1633 THORNWOOD DRIVE
HEATH, OH 43056
Product Code: RCF-IREP
Synonyms: Amines Liquid Corrosive
Product Use: Epoxy Injection Resin
Emergency Phone: CHEMTREC 1 800 424 9300
Product Name: RCF Structural Epoxy Injection Resin
Common Name: Polyamine
02: HAZARDS IDENTIFICATION
HEALTH HAZARD : CATEGORY
Skin Corrosion :1B
Serious Eye Damage: 1
Skin Sensitization :1
H314: Causes severe skin burns and eye damage
H317: May cause an allergic skin reaction
Harmful if inhaled and may cause delayed lung injury. Can cause severe respiratory tract burns. Risk of serious damage to the lungs. May cause nose, throat
and lung irritation. Inhalation of vapors and/or aerosols in high concentration may cause irritation of respiratory system.
Causes skin burns
Causes eye burns. May cause blindness. Severe eye irritation.
If ingested, severe burns of the mouth and throat, as well as a danger of perforation of the esophagus and the stomach
Repeated and/or prolonged exposure to low concentrations of vapors and/or aerosols may cause: Sore throat, Eye disease, Skin Disorders and Allergies.
Hazards not Otherwise Classified
Corrosive, Severe Eye Irritant, Severe Respiratory Irritant, Severe Skin Irritant, and May Cause Sensitization by Skin Contact
03: COMPOSITION / INFORMATION ON INGREDIENTS
04: FIRST AID MEASURES
General Advice: Seek medical advice. If breathing has stopped or is labored, give assisted respirations. Supplemental oxygen may be indicated. If the heart has stopped
trained personnel should begin cardiopulmonary resuscitation immediately.
Inhalation: If respiratory irritation occurs, go to fresh air, flood work area with fresh air. If irritation continues seek medical attention.
Skin Contact: Remove contaminated clothing and shoes. Wash affected area(s) thoroughly with soap and water. If irritation persists, seek medical attention.
SOLVENTS SHOULD NOT BE USED because they carry the irritant into the skin.
General Advice: Flush the eyes with plenty of water for at least 15 minutes. If necessary, gently hold eyelids open during the flush. Immediately seek medical attention. If
medical attention is not promptly available, continue to irrigate for one hour.
General Advice: Obtain immediate medical attention. Do not induce vomiting. Should vomiting occur, be sure to keep the victim’s head below hips to avoid
aspiration of vomit into the lungs.
05: FIRE FIGHTING MEASURES
Special Fire Fighting Procedures: none. Avoid breathing smoke. NFPA Class B-C extinguisher (dry chemical or foam) for class 1C fires. Water spray may be ineffective on fire but can protect fire-fighters
and cool closed containers. Use fog nozzles if water is used. Use supplied breathing masks.
Protection of firefighters: Fire may produce irritating, corrosive and/or toxic gases. Firefighters must use standard protective equipment including flame retardant coat, helmet with face shield,
gloves, rubber boots and in enclosed spaces SCBA. Structural firefighters protective clothing will only provide limited protection.
06: ACCIDENTAL RELEASE MEASURES
Personal Protective Equipment: Splash Goggles, Gloves, Apron, Vapor Respirator
Personal Precautions: Keep people away from and upwind of spill/leak. Avoid inhalation of vapors and spray mists. Keep out of low areas. Do not touch damaged containers or
spilled material unless wearing appropriate protective clothing. Ventilate closed spaces before entering them. Follow facility/company’s emergency plans.
Small Spills: Absorb with an inert material (sand, vermiculite). Sweep or scoop up and put into disposal containers. Flush area immediately with water (prevent water
from entering waterways)..
Large Spills: Dike area far ahead of liquid spill for later disposal. Do not release into sewers or waterways. Absorb with an inert material (sand, vermiculite). Sweep or
scoop up into disposal containers. Flush area immediately with water (prevent water from entering waterways)
Regulatory Requirements: Follow applicable OSH regulations (29 CFR 1910.120). Eliminate all ignition sources (flares, flames including pilot lights, electrical sparks). Persons not wearing
protective equipment should be excluded from the area or until spill clean-up has been completed.
07: HANDLING AND STORAGE
Handling Precautions: For professional use only. Avoid eye/skin contact. Wash after using and before eating or smoking. Avoid breathing vapors. Use as directed. Avoid
uncontrolled mixing with other mixtures (strong acids, bases, and oxidizers). Do not use a solvent to thin. Respiratory protection is required when
ventilation is inadequate. NIOSH/OSHA approved respirators should be provided and worn.
Storage Requirements: Store in a cool/dry location. Do not allow the material to freeze, as the product may be damaged. Store away from sparks and open flames.
08: EXPOSURE CONTROLS/PERSONAL PROTECTION
HMIS PP, H I Splash Goggles, Gloves, Apron, Vapor Respirator
VENTILATION: Provide general or local exhaust ventilation systems to maintain airborne concentrations below OSHA PELs. Local exhaust ventilation is preferred because it
prevents containment dispersion into the work area controlling it as its source.
RESPIRATORY PROTECTION: Seek professional advice prior to respirator selection and use. Follow OSHA respirator regulations (29 CFR 1910.134) and if necessary, wear OSHA/NIOSH
approved respirator. Select respirator based on its suitability to provide adequate worker protection for given working conditions, level of airborne
contamination, and presence of sufficient oxygen.
PROTECTIVE CLOTHING/EQUIPMENT:: Wear chemically protective gloves, boots, and aprons to prevent prolonged or repeated skin contact. Wear protective goggles and face shield, per OSHA
eye and face protection (29 CFR 1910.133).
CONTAMINATED EQUIPMENT: Separate contaminated work clothing from street clothing. Launder before reuse. Remove this material from your work shoes and clean personal protective
OTHER PRECAUTIONS: Never eat, drink or smoke in work areas
This material is not listed by the International Agency for Research on Cancer, the National Toxicology Program, or the Occupational Safety and Health Administration.
09: PHYSICAL & CHEMICAL PROPERTIES
10: STABILITY AND REACTIVITY
Conditions to Avoid: None
Materials to Avoid: Strong oxidizers, acids, and bases
Hazardous Decomposition Products: CO, CO2, NOX
Hazardous Polymerization: None
11: TOXICOLOGICAL INFORMATION
Inhalation: Harmful if inhaled and may cause delayed lung injury. Can cause severe respiratory tract burns. Risk of serious damage to the lungs. May
cause nose, throat and lung irritation. Inhalation of vapors and/or aerosols in high concentration may cause irritation of respiratory
Skin Contact: Causes skin burns.
Eye Contact: Causes eye burns. May cause blindness. Severe eye irritation.
Ingestion: If ingested, severe burns of the mouth and throat, as well as a danger of perforation of the esophagus and the stomach.
Prolonged exposure Repeated and/or prolonged exposure to low concentrations of vapors and/or aerosols may cause: Sore throat, Eye disease, Skin
Disorders and Allergies.
This product contains no listed carcinogens according to IARC, ACGIH, NTP and/or OSHA in concentrations of 0.1 percent or greater. Prolonged contact may result in chemical burns and
12: ECOLOGICAL INFORMATION
Aquatic toxicity: Very toxic to aquatic organisms, may cause long term adverse effects in the
Toxicity to other organisms: No data available
13: DISPOSAL CONSIDERATIONS
When disposed of properly, this material does not meet RCRA classification or listing for hazardous waste. Never dispose of liquid to a landfill. Spilled material should be stabilized of solidified
prior to disposal. Once stabilized/solidified, the material may be disposed of through normal means. Certain localities and state laws have specific disposal requirements for non-hazardous
industrial chemicals. Consult local municipal authorities, landfill personnel or disposal companies for details prior to any disposal activity. Always follow local, state and federal regulations.
14: TRANSPORT INFORMATION
Part A DOT: Not hazardous for domestic ground shipment
Part A IATA: Not regulated
Part A IMDG: UN 3082 Environmentally hazardous substance, liquid, n.o.s. (epoxy resin) 9 III MARINE POLLUTANT
Part B DOT: UN 1760 Corrosive liquids, n.o.s. (nonylphenol) 8 III (ERG #154)
Part B IATA: UN 1760 Corrosive liquids, n.o.s. (nonylphenol) 8 III
Part B IMDG: UN 1760 Corrosive liquids, n.o.s (nonylphenol) 8 III MARINE POLLUTANT – Segregation Group: 18 Alkalis
Placards required over 1,000 lbs
15: REGULATORY INFORMATION
This product is a “Hazardous Chemical” as defined by the Federal OSHA Hazard Communication Standard 29 CFR 1910.1200.
Superfund Amendments and Reauthorization Act of 1986 (SARA)
Hazard Categories Immediate Hazard Yes
Hazard Categories Delayed Hazard Yes
Hazard Categories Fire Hazard No
Hazard Categories Pressure Hazard No
Hazard Categories Reactivity Hazard No
Section 302 Extremely hazardous substance No
Section 311 Extremely hazardous chemical Yes
State Regulations This product does not contain a chemical known to the State of California to cause cancer, birth defects or other reproductive harm.
16: OTHER INFORMATION
Rating Scale: 0-4
HMIS II ratings: Health = 3, Fire = 1, Reactivity = 2
HMIS III ratings: Health = 3, Fire = 1, Physical Hazard = 2
NFPA Ratings: Health = 3, Fire = 1, Reactivity = 2
The information and recommendation in this document are based on the best information available to us at the time of preparation. We make no other warranty, expressed or implied, as to its
correctness or completeness, or as to the results or reliance of this product.
This product has been classified according to the hazard criteria of the CPR and the SDS contains all the
information required by the CPR.
User Responsibility: The information in this document cannot be expected to cover all possible individual situations. As the user has the responsibility to provide a safe workplace, all aspects of
an individual operation should be examined to determine if, or where, precautions, in addition to those described herein, are required. Any health hazard and safety information herein should be
distributed to customers or employees as applicable.
The information contained herein is, to the best of our knowledge and belief, accurate and current as of the date of this SDS. However, since the conditions of handling and use are
beyond our control, we make no guarantee of results and assume no liability for damages incurred by the use of this material. All chemicals may present unknown health hazards and should
be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards which exist. Final determination of suitability of the chemical is
the sole responsibility of the user. No representation or warranties, either expressed or implied, as to its correctness or completeness, or as of merchantability, fitness for a particular
purpose, or any other nature are made hereunder with respect to the information contained herein or the chemical to which the information refers or as to the results or reliance of this
product. It is the responsibility of the user to comply with all applicable federal, state and local laws and regulations.